Coulomb G3

The Coulomb G3 is a single sided mod made by JEB spinner Coulomb.

Construction

Parts needed

List from the FPSB V3:

• 1x G3 (barrel, grip and plastic tube)
• 1x Signo DX (tip and grip)
• 2x Hyperjell (cap and grip)
• 1x Pentel Hybrid Gel Grip (grip and tip)
• 1x Pilot Hi-Tec-C (tip)

Additional Items

• Tape
• An insert

Text tutorial

Preparation

1. Prepare the G3 barrel by sanding the round and square bumps on the front.
2. Cut the clip from the Hyperjell cap.
3. Cut two 0.5 cm sections of Signo DX grip.
4. Cut a 0.9 cm section and a 0.5 cm section of Hyperjell grip.

Assembly

Front side

1. Place one 0.5 cm section of Signo DX grip on the front of the G3 barrel.
2. Place the 0.9 cm section of Hyperjell grip after the Signo DX grip.
3. Screw the G3 tip onto the front of the G3 barrel.
4. Cover the remaining visible section of the G3 front and tip stack with the HGG grip, with the ring side first.
5. Place the Signo tip on the front.
6. Place the Hi-Tec tip on top of the Signo tip. The tip order is: G3 tip, Signo tip, then Hi-Tec tip.

Cap side

1. Place the HGG tip on the Hyperjell cap.
2. Place the larger section of Hyperjell grip on the cap.
3. Place the remaining 0.5 cm section of Signo DX grip after the Hyperjell grip.
4. Place the 0.5 cm Hyperjell grip section after the Signo DX grip.
5. Add tape, then attach the cap to the G3 body.