Coulomb G3

The Coulomb G3 is a single sided mod made by JEB spinner Coulomb.

Construction

Parts needed

List from the FPSB V3:

• 1x G3 (barrel, grip and plastic tube)
• 1x Signo DX (tip and grip)
• 2x Hyperjell (cap and grip)
• 1x Pentel Hybrid Gel Grip (grip and tip)
• 1x Pilot Hi-Tec-C (tip)

Additional Items

• Tape
• An insert

Text tutorial

Preparation

1. Prepare the G3 barrel by sanding the round and square bumps on the front.
2. Cut the clip of the Hyperjell cap.
3. Cut 2x 0.5 cm of Signo DX grip.
4. Cut 0.9 cm and 0.5cm of Hyperjell grip.

Assembly

Front side

1. Put grips in this order on the front of the G3 barrel: 0.5 cm of Signo DX grip and 0.9 cm of
2. On the front of the G3 barrel, stack the tip in this order: G3 tip (screwed on G3), Signo then Hitec.
3. Cover the remaining visible part of G3 front and tipstack with an HGG grip (ring side first).

Cap side

1. In this order, put in the Hyperjell cap: The HGG tip, the big section of Hyperjell grip, 0.5cm of Signo grip, and the 0.5cm section oh Hyperjell grip.
2. Add tape on the G3 body then connect it to the Hyperjell cap.