400¥ G3

The 400¥ G3 is a personal mod made by FPSB modder, VoreTex. The mod's name was based on the price of the parts in Japan.

Construction

Parts needed

List from the pm.pm:

• 2x G3 (barrel, grip, backplug, and plastic tip)
• 1x Signo DX (tip and grip)
• 2x Pilot Supergrip.G (cap and front part)
• 1x Pentel e.ball (grip and clicker)

Additional Items

• Tape
• An insert

Text tutorial

Preparation

1. Cut the clip of the Supergrip.G cap.
2. Cut off the screw thread and small bumps from the Supergrip.G front section.
   

   

   
   
3. Cut the Signo DX grip at the end of the 4th dimple.
4. Prepare the G3 barrel by filing the square and front bump.

Assembly

Front side

1. Cut the E.ball clicker as shown in the source photograph, keeping the wider end. Stack the parts in this order: E.ball clicker (big side), G3 plastic tip, and Signo tip. Secure the stack with tape.
   

   

   
   
2. Place the grips on the G3 front in this order: Signo DX (smaller section) and Eball (striped side first). The Eball grip should cover the tip stack.

Cap side

1. Wrap some tape around the G3 backplug, then put it on the Supergrip.G cap.
2. Add the longer section of Signo DX grip on the Supergrip.G cap.
3. Place the Supergrip.G front part into its cap.
   

   

   
   
4. Add tape on the G3 body then connect it to the Supergrip.G cap.