Itezy-3

The Itezy-3 is a personal single-sided mod made by JEB spinner Iteza.

Construction

Parts needed

Parts and construction from the video below and Penmodding.pm.

• 1x G3 (barrel, grip and plastic tip)
• 2x Signo DX (tips and one grip)
• 1x Hyperjell (cap and grip)
• 1x Hi-Tec (tip)
• 1x Anyball (grip)
• 1x Pilot G2 (grip)

Additional items

• Tape
• An insert

Text tutorial

Preparation

1. Remove the G3 ink tube and backplug, keeping the original G3 grip on the barrel.
2. Remove the Hyper Jell cap clip.
3. Cut the Hyper Jell grip to 2.9 cm.
4. Cut a 1 cm Signo DX grip section.
5. Cut a six-ring Anyball grip section.

Assembly

Front side

1. Fit the 1 cm Signo DX section over the original G3 grip.
2. Screw the plastic G3 tip onto the barrel. Stack a Signo tip over it, followed by the Hi-Tec-C tip.
   

   

   
   
3. Fit the G2 grip over the front, smooth end first. Its striped section should cover the tip stack.
   

   

   
   
4. Fit the six-ring Anyball section over the striped part of the G2 grip.
   

   

   
   

Cap side

1. Fit the base of the remaining Signo tip into the 2.9 cm Hyper Jell grip section.
2. Push the tip and grip assembly into the Hyper Jell cap.
   

   

   
   
3. Add an optional insert. Wrap tape around the rear of the G3 barrel and attach the Hyper Jell cap.
   

   

   
   

Video tutorial

Video tutorial by Iteza.