Itezy-3
From Fen Spinner Wiki
More actions
The Itezy-3 is a personal single-sided mod made by JEB spinner Iteza.
Construction
Parts needed
Parts and construction from the video below and Penmodding.pm.[1]
- 1x G3 (barrel, grip and plastic tip)
- 2x Signo DX (tips and one grip)
- 1x Hyperjell (cap and grip)
- 1x Hi-Tec (tip)
- 1x Anyball (grip)
- 1x Pilot G2 (grip)
Additional items
- Tape
- An insert
Text tutorial
Preparation
- Remove the G3 ink tube and backplug, keeping the original G3 grip on the barrel.
- Remove the Hyper Jell cap clip.
- Cut the Hyper Jell grip to 2.9 cm.
- Cut a 1 cm Signo DX grip section.
- Cut a six-ring Anyball grip section.
Assembly
Front side
- Fit the 1 cm Signo DX section over the original G3 grip.
- Screw the plastic G3 tip onto the barrel. Stack a Signo tip over it, followed by the Hi-Tec-C tip.
- Fit the G2 grip over the front, smooth end first. Its striped section should cover the tip stack.
- Fit the six-ring Anyball section over the striped part of the G2 grip.
Cap side
- Fit the base of the remaining Signo tip into the 2.9 cm Hyper Jell grip section.
- Push the tip and grip assembly into the Hyper Jell cap.
- Add an optional insert. Wrap tape around the rear of the G3 barrel and attach the Hyper Jell cap.
Video tutorial
Video tutorial by Iteza.