Charcoal Latte

The Charcoal Latte is a personal double-sided mod of THPSC spinner Coffy.

Construction

Parts needed

List from Coffy's post

• x1 Nitoms Stalogy (barrel)
• x1 Bic Round Stic (barrel)
• x2 Dr. Grip Playbalance (weight)
• x2 Quantum Geloplus+ (grip)
  • Can be substituted with any other small grip
• x2 Pentel Color Twin (2 bodies)
• x2 Pentel Hybrid Gel Grip (backplugs)
• x1 Signo DX (grip)
• x2 Pilot Opt Shaker (grips)
• x2 decorative grip
  • Coffy uses 6 Tect ring from Eno
• x2 Leftover grip
  • Coffy uses the square part of G3 grip

Text tutorial

Preparation

1. Disassemble the Stalogy and keep only its barrel. Remove the lip at the front.
2. Cut a 3 cm section from the rear of each Color Twin barrel. Keep these rear sections.
3. Cut two 2 cm sections of Bic Round Stic barrel for the connectors.
4. Cut two 1 cm sections of Signo DX grip.

Assembly

1. Insert a Bic connector into each end of the Stalogy barrel. Sand the connectors slightly if needed for a snug fit.
2. Insert a leftover grip into each Bic connector. Add a decorative grip over each connector if desired.
3. Fit a 1 cm Signo DX grip section over the uncut rear end of one Color Twin section.
4. Fit a full Opt grip next to the DX grip, dimpled end first. Stretch the Opt grip from the inside if needed before fitting it.
5. Insert a Playbalance weight into the exposed end of the Opt grip.
6. Insert a Geloplus grip into the Playbalance weight.
7. Insert a HGG backplug into the Geloplus grip. Wrap tape around the backplug if it fits loosely.
   

   

   
   
8. Attach the Color Twin section to a Bic connector.
9. Repeat the end assembly on the other side.