Beige g3

The Beige G3 is a personal mod made by JEB spinner Beige.

Construction

Parts needed

List from Beige's blog:

• 1x Plastic G3 (Barrel, tip)
• 1x Zebra Hyper Jell (Grip)
• 1x HGG (tip, Grip)
• 1x Uni-Ball Signo (tip, grip)
• 1x Sakura Ballsign (New cap)
• 2x Pilot Supergrip（Grips）
• 1x Pilot CHOOSE（Plastic tip)
• 1x Pilot Hi-Tec C（Tip）

Additional Items

• Tape
• An insert

Text tutorial

Preparation

1. Cut the clip of your Zebra Jimnie cap, sand if necessary
2. Remove the backplug, tip, grip and ink of the Plastic G3, then sand down the nubs on the front
3. Cut 3-4mm of the smooth part of G3 grip
4. Cut 3 blocks, 4 blocks and 2 blocks of Pilot Supergrip grips
5. Cut 5mm of the HGG grip

Assembly

1. Put 3 blocks of Pilot Supergrip inside the front of the G3 barrel
2. Add the small segment of g3 grip then 4 stripes on supergrip on the front
3. Tip stack these tips in these order: Signo < HGG < Pilot choose (pilot chose is under), add tape so it's stable
4. Put the tipstack in the hyperjell grip and add the hyperjell grip on the front.

1. Put the Pilot Hi-Tec C tip inside the Hyperjell cap then push 2 blocks of Pilot Supergrip.
2. Add 3 blocks of Supergrip in the Ballsign cap, then put it inside the Hyperjell cap
3. (facultative add an insert)
4. Add the 0.5cm long hgg on the back on the g3 body, then connect it to the hyperjell cap