Beige g3

The Beige G3 is a personal mod made by JEB spinner Beige.

Construction

Parts needed

List from Beige's blog:

• 1x Plastic G3 (barrel, tip, grip)
• 1x Zebra Hyper Jell (grip, cap)
• 1x HGG (tip, Grip)
• 1x Uni-Ball Signo (tip, grip)
• 1x New Sakura Ballsign (cap)
• 2x Pilot Supergrip（Grips）
• 1x Pilot CHOOSE（Plastic tip)
• 1x Pilot Hi-Tec-C（Tip）

Additional Items

• Tape
• An insert

Text tutorial

Preparation

1. Remove the Hyper Jell cap clip and sand the cut edge if necessary.
2. Remove the backplug, tip, grip and ink tube from the plastic G3. Sand down the nubs at the front.
3. Cut a 3–4 mm section from the smooth part of the G3 grip.
4. Cut SuperGrip sections of three, four and two rings, plus a second three-ring section for the Ballsign cap.
5. Cut a 5 mm section of HGG grip.

Assembly

1. Insert a three-ring SuperGrip section into the front of the G3 barrel.
2. Fit the small G3 grip section over the front, followed by the four-ring SuperGrip section.
3. Stack the tips with the plastic CHOOSE tip underneath, the HGG tip over it and the Signo tip outermost. Secure the stack with tape.
4. Place the tip stack inside the Hyper Jell grip and fit the grip onto the front.

1. Insert the two-ring SuperGrip section into the Hyper Jell cap, followed by the Hi-Tec-C tip.
2. Remove the Ballsign cap clip. Insert the remaining three-ring SuperGrip section into that cap, then insert the Ballsign cap into the Hyper Jell cap.
3. Add an optional insert to the barrel.
4. Fit the 5 mm HGG grip section over the rear of the G3 barrel, then attach the Hyper Jell cap.