Sausage mod: Difference between revisions
From Fen Spinner Wiki
More actions
No edit summary |
Validate text tutorial against recovered source; clarify construction and add heading reference and sourced images |
||
| Line 24: | Line 24: | ||
* Tape | * Tape | ||
===Text tutorial=== | ===Text tutorial<ref>[https://penmodding.pm/archives/2491 Sausage mod tutorial]</ref>=== | ||
====Preparation==== | ====Preparation==== | ||
# Cut the Fibracolor body to 5. | # Cut the Fibracolor body to 5.3 cm | ||
# Cut the clip of the G3 cap, and sand the nub. | # Cut the clip of the G3 cap, and sand the nub. | ||
# Cut your Sailor grip to 1 block of 6 rings. | # Cut your Sailor grip to 1 block of 6 rings. | ||
# Cut 0. | # Cut 0.5 cm of Signo broad grip. | ||
====Assembly==== | ====Assembly==== | ||
=====Front side===== | =====Front side===== | ||
# Add the small emboss cap to the emboss body. | # Add the small emboss cap to the emboss body. | ||
# | # Place the Colorgel tip inside the cap followed by the small Signo grip section. | ||
=====Cap side===== | =====Cap side===== | ||
# Inside the G3 cap, add in this order: G1 tip and Fibracolor barrel<br>[[File:Sausagemodcap.jpg | # Inside the G3 cap, add in this order: G1 tip and Fibracolor barrel<br>[[File:Sausagemodcap.jpg|left|thumb|200px|]]<br clear=all> | ||
# | # Fit the Sailor grip section over the G3 cap. Connect the Fibracolor section to the Emboss rear, adding tape as needed. | ||
==References== | ==References== | ||
Latest revision as of 21:53, 2 October 2026
The Sausage mod is a personal mod made by Whizz.
Construction
Parts needed
List from the UPSB V3[1]:
- 1x G3 (cap)
- 1x Signo Broad (grip)
- 1x Pilot G1 (tip)
- 1x Tsukineko Emboss Dual Pen (body and cap)
- 1x Sailor (grip)
- 1x Stabilo Colorgel (tip)
- 1x Fibracolor marker (barrel)
Additional Items
- Tape
Text tutorial[2]
Preparation
- Cut the Fibracolor body to 5.3 cm
- Cut the clip of the G3 cap, and sand the nub.
- Cut your Sailor grip to 1 block of 6 rings.
- Cut 0.5 cm of Signo broad grip.
Assembly
Front side
- Add the small emboss cap to the emboss body.
- Place the Colorgel tip inside the cap followed by the small Signo grip section.
Cap side
- Inside the G3 cap, add in this order: G1 tip and Fibracolor barrel
- Fit the Sailor grip section over the G3 cap. Connect the Fibracolor section to the Emboss rear, adding tape as needed.
