Sausage mod

The Sausage mod is a personal mod made by Whizz.

Construction

Parts needed

List from the UPSB V3:

• 1x G3 (cap)
• 1x Signo Broad (grip)
• 1x Pilot G1 (tip)
• 1x Tsukineko Emboss Dual Pen (body and cap)
• 1x Sailor (grip)
• 1x Stabilo Colorgel (tip)
• 1x Fibracolor marker (barrel)

Additional Items

• Tape

Text tutorial

Preparation

1. Cut the Fibracolor body to 5.3 cm
2. Cut the clip of the G3 cap, and sand the nub.
3. Cut your Sailor grip to 1 block of 6 rings.
4. Cut 0.5 cm of Signo broad grip.

Assembly

Front side

1. Add the small emboss cap to the emboss body.
2. Place the Colorgel tip inside the cap followed by the small Signo grip section.

Cap side

1. Inside the G3 cap, add in this order: G1 tip and Fibracolor barrel
   

   

   
   
2. Fit the Sailor grip section over the G3 cap. Connect the Fibracolor section to the Emboss rear, adding tape as needed.