Sausage mod: Difference between revisions
From Fen Spinner Wiki
More actions
mNo edit summary |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 8: | Line 8: | ||
|cog= | |cog= | ||
}} | }} | ||
The '''Sausage mod | The '''Sausage mod''' is a personal mod made by Whizz. | ||
==Construction== | ==Construction== | ||
| Line 17: | Line 17: | ||
* 1x [[Uni-Ball Signo|Signo Broad]] (grip) | * 1x [[Uni-Ball Signo|Signo Broad]] (grip) | ||
* 1x [[Pilot G1]] (tip) | * 1x [[Pilot G1]] (tip) | ||
* 1x [[Tsukineko Emboss Dual Pen] (body and cap) | * 1x [[Tsukineko Emboss Dual Pen]] (body and cap) | ||
* 1x [[Sailor IC Liquid Gel|Sailor]] (grip) | * 1x [[Sailor IC Liquid Gel|Sailor]] (grip) | ||
* 1x [[Stabilo Colorgel]] (tip) | * 1x [[Stabilo Colorgel]] (tip) | ||
Latest revision as of 21:26, 30 January 2025
The Sausage mod is a personal mod made by Whizz.
Construction
Parts needed
List from the UPSB V3[1]:
- 1x G3 (cap)
- 1x Signo Broad (grip)
- 1x Pilot G1 (tip)
- 1x Tsukineko Emboss Dual Pen (body and cap)
- 1x Sailor (grip)
- 1x Stabilo Colorgel (tip)
- 1x Fibracolor marker (barrel)
Additional Items
- Tape
Text tutorial
Preparation
- Cut the Fibracolor body to 5.3cm
- Cut the clip of the G3 cap, and sand the nub.
- Cut your Sailor grip to 1 block of 6 rings.
- Cut 0.5cm of Signo broad grip.
Assembly
Front side
- Add the small emboss cap to the emboss body.
- Put the Colorgel tip inside the cap followed by the small Signo grip section.
Cap side
- Inside the G3 cap, add in this order: G1 tip and Fibracolor barrel
- Add tape on the emboss body (front part/backplug) then connect it to the G3 cap.
