SEVEN G3

The SEVEN G3 is a personal mod made by JEB spinner SEVEN.

Construction

Parts needed

List from Penmodding Wiki's article:

• 1x Plastic G3 (Barrel, tip)
• 1x Zebra Jimnie (Cap)
• 1x Zebra Hyper Jell (Grip) (You can use the Zebra Jimnie instead)
• 1x HGG (Grip)
• 1x Signo DX (tip, grip)
• 1x Uni-Ball Lakubo (Grip)
• 1x Dong-A Anyball (Grip)
• 1x Ohto Metalic Gel (Tip)
• 1x Ohto Needle-Point (Tip)
• 1x Pastel Color (Grip)

Additional Items

• Aluminium tape (Any kind of tape should work)
• Electric tape
• 2 inserts (Optionnal)
  

  

  Original insert of SEVEN G3

  
  

Text tutorial

Preparation

1. Cut the clip of your Zebra Jimnie cap, sand if necessary
2. Remove the backplug, tip, grip and ink of the Plastic G3, then sand down the nubs on the front
3. Cut 2.6 cm of Zebra Hyper Jell grip
4. Cut 2 blocks of Dong-A Anyball grip, then cut 1 block of Dong-A Anyball grip
5. Cut 2-3 mm of Pastel Color grip
6. Cut ~3mm of HGG grip
7. Cut 6 mm of the Uni-Ball Signo DX grip
8. Remove the Uni-Ball Lakubo grip, the Ohto Needle-Point, Ohto Metalic Gel and the Uni-Ball Signo DX tips

Assembly

1. Put the cutted section of HGG on the base of the Uni-Ball Signo tip. Put these inside the Zebra Jimnie cap
   

   

   
   
2. Stuff one section of Dong-A Anyball grip inside the Zebra Hyper Jell grip
   

   

   
   
3. Add the Zebra Hyper Jell grip inside the Zebra Jimnie cap (Facultative: Wrap an insert around the Zebra Hyper Jell grip).
   

   

   
   
4. Add the Pastel Color grip right after
5. Stuff the 2 blocks of Dong-A Anyball grip inside the front of the Plastic G3, screw back the Plastic G3 tip
   

   

   
   
6. Add the Ohto Metalic Gel tip onto the Plastic G3 tip, then put the Ohto Needle-Point tip and put it on top of the Ohto Metalic Gel tip. (Wrap some tape to make it stable.)
   

   

   
   
7. Add 6 mm of the Uni-Ball Signo DX grip on the front of the Plastic G3 body, then add the Uni-Ball Lakubo grip (flat side first). The grip should cover the base of all 3 tips.
8. (Facultative) Add an insert inside the Plastic G3 body.
9. Put some tape on the back of the Plastic G3 barrel and put the Zebra Jimnie cap on top

Video Tutorial

Video tutorial by Septopus.