Watto G3
From Fen Spinner Wiki
More actions
The Watto G3 is a personal mod made by JEB spinner Watto. It is known for its distinct appearance and difficult modding process.
Construction
Parts needed
List from Kzzn's blog:[1]
- 2x G3 (barrel, cap, grip, cap rubbers)
- 1x Playcolor (barrel)
- 1x G2 (grip)
- 1x Hyperjell (cap, grip)
- 1x Anyball (grip)
- 1x Airblanc (grip)
- 1x Sailor (grip)
- 1x Gel Roller (tip, cap rubber)
- 1x Round Stic (backplug)
- 1x Airfit (ring)
- 1x Fit Curve (ring)
- 1x HGG (tip)
Text tutorial
- Remove G3 grip, inktube, tip and backplug, then sand down the nubs on the front to prepare the barrel.
- Cut 5mm Hyperjell segment.
- Place gel roller tip onto round stic backplug as shown.
- Put the tip-backplug stack into the larger hyperjell segment.
- Cut a 1.4cm segment of Playcolor barrel from the back.
- Cut a 2.7cm segment of Playcolor barrel from the front.
- Cut a 1.2cm segment of G3 cap from the opening.
- Remove both G3 cap rubbers from the cap and cut holes in them.
- Place one modified G3 cap rubber into the HGG tip.
- Put the HGG tip with cap rubber inside onto the front Playcolor segment.
- Place airfit ring over sailor segment (two rings)
- Place ring and sailor onto front playcolor segment, then place single front stripe cut from anyball behind the ring, then place g3 cap segment on top as shown.
- Place 4 stripes of cut G3 grip into the back Playcolor segment. Then wedge the back PC2 assembly onto the front assembly.
- Place second G3 cap rubber between the HGG tip and G3 grip inside the PC2 barrel.
- Cut a 1.6cm segment of Airblanc grip and place it over the 1.4cm Playcolor barrel segment.
Video tutorial
Video tutorial by VORE-TEX.