RiAsON G3

The RiAsON G3 is a single-sided mod made by JEB spinner RiAsON. This mod is a variation of the GJH mod. As RiAsON never shared the tutorial of the original mod, the tutorial presented here is one of a replica.

Construction

Parts needed

List from the UPSB V3:

• 1x G3 (Metal tip, barrel, grip and cap)
• 1x Jedo (tip)
• 3x HGG (2 tips and 3 grip)
• 2x Dong-A Anyball (grips)
  • Using only 1 grip is possible.
• 1x Pilot AirBlanc (grip)

Additional Items

• Tape
• An insert
• Glue

Text tutorial

1. Prepare a working GJH base, including its Jedo mechanism and front tip, then remove the G3 grip from inside the cap.

Preparation

1. Cut some sections of Airblanc grip.
2. Cut a small section of one HGG grip.
3. Cut 2.5 cm of another HGG grip.
4. Cut some blocks of Anyball grips.
5. Prepare the G3 barrel by filing the square and front bump.

Assembly

Front side

1. Add the HGG grip at the front of the G3.
2. Stack the tips in this order inside the HGG grip: HGG tip onto Jedo tip (Use glue if necessary).
3. Overgrip the HGG grip in this order: 2 blocks of Anyball, a Airblanc section, 2 blocks of anyball, a space (around 1 mm large), and a big anyball ring.

Cap side

1. Place the 2.5 cm of HGG and a small section of HGG grip (in this order) inside the G3 cap.
2. Put some Anyball ring onto the G3 cap.
3. Add some tape on the end of the G3 barrel, then connect the G3 cap to it.