KaD BM2

The KaD BM2 is a double-sided mod made by PPP spinner KaD.

Construction

Parts needed

Parts list from the picture below:

• x2 Factis BM2 (barrel)
• x2 X-POWER/tome (grips)
• x2 Giotto Turbo Maxi (barrel)
  • Only one can be used
• x2 ZhiGao V24/V39 (grip)
• x1 Tsukineko Emboss Dual Pen (small cap)
• x2 Dong-A Com.ssa (barrels)
• x2 M6 cap nut

=Additional items

• Tape

Text tutorial

Preparation

1. Cut two 3 cm of Giotto barrel.
2. Cut two 8.9 cm from the Factis barrel.
3. Cut 1 cm from the Emboss small cap.
4. Cut one 3 cm and two 4 cm from Comssa barrel (4 cm pieces should be cut from the front and the 3 cm one from the middle).
5. Cut two 4 mm of Tornado grip.

Assembly

1. Wrap some tape around the 4 cm Comssa piece then put it inside the Giotto piece (1.5 cm should remain visible).
2. Place the Tornado grip onto the M6 cap nut.
3. Place the last step onto the Giotto part then slide the V24/39 grip onto it (stretch if necessary).
4. Place the assembly inside the Factis barrel.
5. Repeat.
6. Place the 1 cm of Emboss cap on the 3 cm Comssa then connect both Factis barrels onto it.

Image tutorial