KaD BM2

The KaD BM2 is a double sided mod made by PPP spinner KaD.

Construction

Parts needed

List from the picture below:

• x2 Factis BM2 (barrel)
• x2 X-POWER/tome (grips)
• x2 Giotto Turbo Maxi (barrel)
  • Only one can be used
• x2 ZhiGao V24/V39 (grip)
• x1 Tsukineko Emboss Dual Pen (small cap)
• x2 Dong-A Com.ssa (Barrels)
• x2 M6 cap nut

Additional Items

• tape

Text tutorial

Preparation

1. Cut 2x 3cm of Giotto barrel.
2. Cut 2x 8.9cm from the Factis barrel.
3. Cut 1cm from the Emboss small cap.
4. Cut 1x 3cm and 2x 4cm from Comssa barrel (4cm pieces should be cut from the front and the 3cm one from the middle).
5. Cut 2x 4mm of Tornado grip.

Assembly

1. Wrap some tape around the 4cm comssa piece then put it inside the Giotto piece (1.5cm should remain visible).
2. Put the tornado grip onto the M6 cap nut.
3. Put the last step onto the Giotto part then slide the V24/39 grip onto it (stretch if necessary).
4. Put the assembly inside the Factis barrel.
5. Repeat.
6. Put the 1cm of emboss cap on the 3cm comssa then connect both Factis barrels onto it.

Image tutorial