Dentoru Emboss

Dentoru Emboss is an adjustable mod made by Dentoru. It was created to emulate the look and feel of the Menowa* Reimei but on an Emboss body.

Construction

Parts needed

• 1x Emboss (Body, backplug)
• 2x Giotto Turbo Maxi (Two bodies)
• 2x 2ballpen+sharpen or can be substituted with Zebra Z-Grip (Two grips)
• 4x Anyball (Two grips)
• 2x Playcolor 2 (Two small caps)
• 2x Pilot G2 (Two grips)
• 1x Penzgear (2/4/6 Rings)
• 1x Pentel Hybrid Gel Grip or Pentel RSVP or similar (thin grip).
• Tape (Original uses cellophane tape)

Text tutorial

1. Cut a 7-ring section from the back of two Anyball grips (4-7)
2. Cut a 4-ring section, two rings away from the front of two Anyball grips (2-4-5)
3. Cut 4 rings from the G2 grips; keep the larger section.
4. Cut 3 cm of the Giotto barrels from the back end
5. Cut two 3 mm sections from your thin grip
6. Cut two 3 cm sections from the smooth part of the 2ballpen+sharpen grips
7. Clean and empty the Emboss.
8. Place the backplug back into the Emboss
   

   

   
   
9. Place a thin grip section on the front of a PC2 small cap
   

   

   
   
10. Place the G2 grip, cut-side first, onto the front of the PC2 cap leaving 1 cm of the cap exposed
    

    

    
    
11. Push 1-3 penzgear rings into the G2 grip
    

    

    
    
12. Place the package into the Giotto barrel from the back end
    

    

    
    
13. Put 7 section Anyball, 4 section Anyball, and 2ballpen+sharpen section onto the package
    

    

    
    
14. Repeat steps 9-13 to make a second assembly.
15. Wrap tape around the Emboss front and backplug until the packages fit onto the ends snugly
16. Push the packages onto the Emboss