KAtts Bullet mod

The kAtts Bullet mod is a double-sided mod made by kAtts which he used in his Pen Spinning World Tournament 2017 participation.

Construction

Parts needed

Parts list from the video below:

• x2 Giotto Turbo Maxi (2 body)
• x2 Pilot Dr. Grip (grip)
• x2 Gel roller (grips)
• x2 Nato bullet 7.62×51 mm
• x1/2 Dong-A Anyball (grip; 2 for a perfectly symmetrical mod)
• x1 Tombow Playcolor2 (body)

Text tutorial

1. Cut both Dr. Grip grips in half (keep the side with the lip).
2. Cut two 3-block pieces of Anyball grip.
3. Cut 6 cm from the front of your Playcolor2 body.
4. Cut the front of your Giotto Turbo Maxi barrel and remove the backplug.
5. Cut the Gel roller grips to the length of the base of the NATO bullet tips.
6. Put the Nato Bullet tips with the Gel roller grips inside the front side of the Giotto Turbo Maxi barrel (the tip should stay visible from the outside of the barrel).
7. Put 3 blocks of Anyball grips on the Giotto Turbo Maxi barrel (tip side) then half of a Dr. Grip on the Giotto Turbo Maxi barrel to cover the tip.
8. Repeat on the other side and connect using the 6cm of Playcolor2 body.

Video tutorial

Video tutorial by kAtts.