KAtts Bullet mod

The kAtts Bullet mod is a double sided mod made by kAtts which he used in his Pen Spinning World Tournament 2017 participation.

Construction

Parts needed

List from the video below

• x2 Giotto Turbo Maxi (2 body)
• x2 Pilot Dr. Grip (grip)
• x2 Gel roller (Grips)
• x2 Nato bullet 7,62X51mm
• x1/2 Dong-A Anyball (Grip (2 for a perfectly symetrical mod))
• x1 Tombow Playcolor2 (body)

Text tutorial

1. Cut your 2 Dr. Grip grips in half (keep the side with the lip).
2. Cut 2x 3 block of Anyball grip.
3. Cut 6cm from the front of your Playcolor2 body.
4. Cut the front of your Giotto Turbo Maxi barrel and remove the backplug.
5. Cut the Gel roller grips to the lengh of the base of the Nato Bullet tips.
6. Put the Nato Bullet tips with the Gel roller grips inside the front side of the Giotto Turbo Maxi barrel (The tip should stay visible from the outside of the barrel).
7. Put 3 blocks of Anyball grips on the Giotto Turbo Maxi barrel (tip side) then the half of Dr. Grip on the Giotto Turbo Maxi barrel to cover the tip.
8. Repeat on the other side and connect using the 6cm of Playcolor2 body.

Video tutorial

Video tutorial by kAtts.