KaD BM2

The KaD BM2 is a double-sided mod made by PPP spinner KaD.

Construction

Parts needed

Parts list from the picture below:

• x2 Factis BM2 (barrel)
• x2 X-POWER/tome (grips)
• x2 Giotto Turbo Maxi (barrel)
  • Only one can be used
• x2 ZhiGao V24/V39 (grip)
• x1 Tsukineko Emboss Dual Pen (small cap)
• x2 Dong-A Com.ssa (barrels)
• x2 M6 cap nut

=Additional items

• Tape

Text tutorial

Preparation

1. Cut two 3 cm of Giotto barrel.
2. Cut two 8.9 cm from the Factis barrel.
3. Cut 1 cm from the Emboss small cap.
4. Cut one 3 cm and two 4 cm from Comssa barrel (4cm pieces should be cut from the front and the 3cm one from the middle).
5. Cut two 4 mm of Tornado grip.

Assembly

1. Wrap some tape around the 4 cm Comssa piece then put it inside the Giotto piece (1.5 cm should remain visible).
2. Put the Tornado grip onto the M6 cap nut.
3. Put the last step onto the Giotto part then slide the V24/39 grip onto it (stretch if necessary).
4. Put the assembly inside the Factis barrel.
5. Repeat.
6. Put the 1 cm of Emboss cap on the 3 cm Comssa then connect both Factis barrels onto it.

Image tutorial