SEVEN G3
From Fen Spinner Wiki
More actions
Construction
Parts needed
List from Penmodding Wiki's article:[1]
- 1x Plastic G3 (Barrel, tip)
- 1x Zebra Jimnie (Cap)
- 1x Zebra Hyper Jell (Grip) (You can use the Zebra Jimnie instead)
- 1x HGG (Grip)
- 1x Uni-Ball Signo DX (tip, grip)
- 1x Uni-Ball Lakubo (Grip)
- 1x Dong-A Anyball (Grip)
- 1x Ohto Metalic Gel (Tip)
- 1x Ohto Needle-Point (Tip)
- 1x Pastel Color (Grip)
Additional Items
- Aluminium tape (Any kind of tape should work)
- Electric tape
- 2 inserts (Facutative)
Text tutorial
Mise en place
- Cut the clip of your Zebra Jimnie cap, sand if necessary
- Remove the backplug, tip, grip and ink of the Plastic G3, then sand down the nubs on the front
- Cut 2.6 cm of Zebra Hyper Jell grip
- Cut 2 blocks of Dong-A Anyball grip, then cut 1 block of Dong-A Anyball grip
- Cut 2-3 mm of Pastel Color grip
- Cut ~3mm of HGG grip
- Cut 6 mm of the Uni-Ball Signo DX grip
- Remove the Uni-Ball Lakubo grip, the Ohto Needle-Point, Ohto Metalic Gel and the Uni-Ball Signo DX tips
Assembly
- Put the cutted section of HGG on the base of the Uni-Ball Signo tip. Put these inside the Zebra Jimnie cap
- Stuff one section of Dong-A Anyball grip inside the Zebra Hyper Jell grip
- Add the Zebra Hyper Jell grip inside the Zebra Jimnie cap (Facultative: Wrap an insert around the Zebra Hyper Jell grip).
- Add the Pastel Color grip right after
- Stuff the 2 blocks of Dong-A Anyball grip inside the front of the Plastic G3, screw back the Plastic G3 tip
- Add the Ohto Metalic Gel tip onto the Plastic G3 tip, then put the Ohto Needle-Point tip and put it on top of the Ohto Metalic Gel tip. (Wrap some tape to make it stable.)
- Add 6 mm of the Uni-Ball Signo DX grip on the front of the Plastic G3 body, then add the Uni-Ball Lakubo grip (flat side first). The grip should cover the base of all 3 tips.
- (Facultative) Add an insert inside the Plastic G3 body.
- Put some tape on the back of the Plastic G3 barrel and put the Zebra Jimnie cap on top
Video Tutorial
Video tutorial by Septopus.