Kagami DC

Regardless of its asymmetric design, Kagami DC is a balanced mod created by Kagami that has been popularized due to its unique design yet spinning potential.

Some think of Kagami DC as a mod that was created using spare parts.

Construction

Parts needed

• 1x Pentel Art Color Twin
• 1x Pentel Color Twin
• 2x Zebra Sarasa（grip）
• 1x Pilot Supergrip（grip - you only need the rings section）
• 1x Dong-a Anyball（grip）
• 2x Pilot Vega Gel（tip）

Text tutorial

1. Disassemble the Pentel Art Color Twin fully leaving only the body.
2. Remove the inside of both the large Color Twin cap and the Art Color cap.
3. Cut down both the smaller caps until they are the same length as the Art Color backplug.
4. Tightly fit the smaller Art Color cap on the back of the Art Color body and the smaller Color Twin cap on front.
5. Cut each of the Zebra Sarasa grips down to 2 cm.
6. Cut 1 section of 2 rings of Dong-a Anyball.
7. Cut 2 sections of 1 ring of Pilot Supergrip.
8. Place the Dong-a Anyball section on the smaller Color Twin cap.
9. Unscrew the tips from the Pilot Vega Gel and place them in both the larger caps.
10. Place each of the Supergrip rings into one Sarasa grip, then place one on the end of each larger cap.
11. Place the larger caps on the two ends of the body.

Video tutorial

Video tutorial by Kagami himself.