Kagami DC
From Fen Spinner Wiki
More actions
The Kagami DC is a mod created and popularized by Kagami. Despite its asymmetric design, it's still known as a double sided mod.
Construction
Parts needed
- 1x ACT (cap, barrel, backplug)
- 1x CT (cap, backplug)
- 2x Old Sarasa (grip)
- 1x SuperGrip (grip)
- 1x Anyball (grip)
- 2x Pilot Vega Gel (tip)
Text tutorial
- Disassemble the ACT fully leaving only the body.
- Hollow both the large CT cap and the large ACT cap.
- Cut down both the smaller caps until they are the same length as the ACT backplug.
- Tightly fit the smaller ACT cap on the back of the ACT body and the smaller CT cap on front.
- Cut each of the Sarasa grips down to 2 cm.
- Cut 1 section of 2 rings of Anyball.
- Cut 2 sections of 1 ring of SuperGrip.
- Place the Anyball section on the smaller CT cap.
- Unscrew the tips from the Pilot Vega Gel and place them in both the larger caps.
- Place each of the SuperGrip rings into one Sarasa grip, then place one on the end of each larger cap.
- Place the larger caps on the two ends of the body.
Tutorial assembled from Kagami's YouTube tutorial and Penmodding.pm[1].
Video tutorial
Video tutorial by Kagami.