Neptunus Mod
From Fen Spinner Wiki
More actions
 | This article contains leaked information from an anonymous source. The authenticity has been regarded as reasonable by Fenspinner Wiki, but cannot be guaranteed. Fenspinner Wiki has a policy of never disclosing the identity of leakers, and presents the information as-is. |
The Neptunus Mod is a pen mod created by FPSB modder VORE-TEX for the JEB spinner VAIN during the production of his X Incipiens Stabilus CV.
Construction
Parts needed
- 2x Stalogy (Backplugs)
- 2x Juice Up (Tips)
- 2x Anyball (grip sections)
- 2x Airblanc (1.9cm grip sections)
- 2x V-Feel 05 (Body and grip)
- 2x Signo/similar (thin grip sections)
- 1x Sarasa (grip)
- 1x Tombow Playcolor2 (body)
- 2x G-Spec/Playborder (Undergrips)
Text tutorial
- Shorten Stalogy backplugs to 8 or 9mm in total length by cutting.
- Cut the G-spec/Playborder undergrip to fit over the Stalogy backplugs and place them.
- Insert the flared ends of the Stalogy backplugs into Juice Up tips.
- Place a section of Signo or other thin grip over the entire assembly, leaving a section of the tip poking out.
- Cut V-Feel barrels to 3.6cm.
- Cut Sarasa grip in half and place on the barrels.
- Cut and place V-Feel grip to overhang off the end of the V-Feel barrel.
- Insert the tip package into the V-Feel grip.
- Cut 1.9cm of Airblanc grip on the ring side and place onto the end of the V-Feel grip.
- Cut 3 stripes of anyball and place on at the ends on either side.
- Cut pieces of G-Spec/Playborder grip and place on the Playcolor2 front and backplugs.
- Mount V-feel barrels on grips and done.