MeowSTA

The MeowSTA is an inverted mod made by Xeran as of 27/08/2020.

History

MeowSTA intends to be a heavy mod for slow spinning which is slightly thinner than Emboss.

The name was changed from Fengear to MeowSTA on 10/02/2020.

Construction

Parts needed

• 2x Emboss (Two small caps)
• 2x Pilot Opt Shaker (Two tips)
• 2x Uni-ball Signo (Two tips)
• 2x Pilot Dr. Grip Shaker (Two grips)
• 2x Pentel ColorTwin (Two caps)
• 2x Pilot Supergrip (Two grips)
• 1x Pilot G2 (Grip)
• 2x Pilot Airblanc (Two grips)
• 1x STA Aquarelle (Barrel)
• 2x Tulip Dual-Tip (Two backplugs)

Other Materials

• Masking Tape

Text Tutorial

1. Empty and clean the STA barrel
2. Take backplugs off the Tulip markers and remove the nibs
3. Cut 1cm from the lip of the small Emboss caps
4. Cut DGGs in half
5. Cut 2 separate rings from the middle of the ridged section of the G2 grip
6. Cut 3 sections from the front of the Supergrips
7. Cut 1cm from the back of the Airblancs
8. Hollow the CT caps
9. Push one of the cut Supergrip sections into the CT cap, cut side facing in
10. Put an inverted Signo tip into the Supergrip grip, the tip should sit flush with the grip
    

    

    
    
11. Put inverted Opt tip into the Signo tip
12. Push one of the short Emboss cap section over the Opt tip, cut side facing out
13. Put a G2 ring into the small Emboss cap
    

    

    
    
14. Put a front half of DGG onto the Emboss and CT cap. Small cap and g2 section should be flush with the inside of the DGG
15. Put Airblanc section onto front of Tulip backplug
16. Push Tulip backplug into CT cap
17. Wrap tape onto back of the Tulip backplug until it can fit snugly into the STA barrel
    

    

    
    
18. Repeat steps 9-17 for the other cap
19. Push assemblies onto STA barrel
20. Complete