MeowSTA

The MeowSTA is an inverted mod made by Xeran as of 27/08/2020.

History

MeowSTA intends to be a heavy, slow moving mod to fit Xeran's preferences and style. It has been Xeran's main mod as of 27/08/2020 to now.

The mod has gone through 3 versions of weight package construction with the final version to be called MeowSTA being created on 20/09/2020. There has been 4 name changes since the first creation of the mod; Originally the mod was called FenSTA but was changed shortly after to Fengear as it predated V01d's Fengear mod and Xeran wanted to own the mod name as a joke towards V01d. It began to be referred to as the Catgear by the creator and others as V01d's Fengear became more popular. Xeran officially changed the name to MeowSTA after the recommendation from V01d on 10/02/2020.

Construction

Parts needed

2x Emboss (Two small caps)
2x Pilot Opt Shaker (Two tips)
2x Uni-ball Signo (Two tips)
2x Pilot Dr. Grip Shaker (Two grips)
2x Pentel ColorTwin (Two caps)
2x Pilot SuperGrip (Two grips)
1x Pilot G-2 (Grip)
2x Pilot AirBlanc (Two grips)
1x STA Aquarelle (Barrel)
2x Tulip Dual-Tip (Two backplugs)

Other Materials

Masking Tape

Text Tutorial

Empty and clean STA barrel with acetone/nail polish remover
Take backplugs off the Tulip markers and remove the nibs
Cut 1cm from the lip of the small Emboss caps
Cut DGGs in half
Cut 2 separate rings from the middle of the ridged section of the G-2 grip
Cut 3 sections from the front of the Supergrips
Cut 1cm from the back of the Airblancs
Hollow the CT caps
Push one of the cut Supergrip sections into the CT cap, cut side in
Put an inverted Signo tip into the Supergrip grip, the grip and tip should sit flush with end of the cap
Put inverted Opt tip onto the Signo tip
Push one of the short Emboss cap section over the Opt tip, cut side out
Put a G-2 ring into the small Emboss cap
Put front half of DGG onto the Emboss and CT cap, small cap and g2 section should be flush with the inside of the DGG
Put AirBlanc section onto front of Tulip backplug
Push Tulip backplug into CT cap
Wrap tape onto back of the Tulip backplug until it can fit snugly into the STA barrel
Repeat steps 9-17 for the other cap
Push assemblies onto STA barrel
Complete