Kagami DC

The Kagami DC is a mod created and popularized by Kagami. Despite its asymmetric design, it's still known as a double sided mod.

Construction

Parts needed

• 1x ACT
• 1x CT
• 2x Old Sarasa（grip）
• 1x SuperGrip（grip - you only need the rings section）
• 1x Anyball（grip）
• 2x Pilot Vega Gel（tip）

Text tutorial

1. Disassemble the ACT fully leaving only the body.
2. Hollow both the large CT cap and the large ACT cap.
3. Cut down both the smaller caps until they are the same length as the ACT backplug.
4. Tightly fit the smaller ACT cap on the back of the ACT body and the smaller CT cap on front.
5. Cut each of the Sarasa grips down to 2 cm.
6. Cut 1 section of 2 rings of Anyball.
7. Cut 2 sections of 1 ring of SuperGrip.
8. Place the Anyball section on the smaller CT cap.
9. Unscrew the tips from the Pilot Vega Gel and place them in both the larger caps.
10. Place each of the SuperGrip rings into one Sarasa grip, then place one on the end of each larger cap.
11. Place the larger caps on the two ends of the body.

Tutorial assembled from Kagami's YouTube tutorial and Penmodding.pm.

Video tutorial

Video tutorial by Kagami.