MeowSTA

The MeowSTA is an inverted mod made by Xeran as of 27/08/2020.

History

MeowSTA intends to be a heavy, slow moving mod. It's Xeran's main mod.

Xeran changed the name from FenSTA to MeowSTA after V01d's recommendation on 10/02/2020.

Construction

Parts needed

• 2x Emboss (Two small caps)
• 2x Pilot Opt Shaker (Two tips)
• 2x Uni-ball Signo (Two tips)
• 2x Pilot Dr. Grip Shaker (Two grips)
• 2x Pentel ColorTwin (Two caps)
• 2x Pilot SuperGrip (Two grips)
• 1x Pilot G-2 (Grip)
• 2x Pilot AirBlanc (Two grips)
• 1x STA Aquarelle (Barrel)
• 2x Tulip Dual-Tip (Two backplugs)

Other Materials

• Masking Tape

Text Tutorial

1. Empty and clean STA barrel with acetone/nail polish remover
2. Take backplugs off the Tulip markers and remove the nibs
3. Cut 1cm from the lip of the small Emboss caps
4. Cut DGGs in half
5. Cut 2 separate rings from the middle of the ridged section of the G-2 grip
6. Cut 3 sections from the front of the Supergrips
7. Cut 1cm from the back of the Airblancs
8. Hollow the CT caps
9. Push one of the cut Supergrip sections into the CT cap, cut side in
10. Put an inverted Signo tip into the Supergrip grip, the grip and tip should sit flush with end of the cap
11. Put inverted Opt tip onto the Signo tip
12. Push one of the short Emboss cap section over the Opt tip, cut side out
13. Put a G-2 ring into the small Emboss cap
14. Put front half of DGG onto the Emboss and CT cap, small cap and g2 section should be flush with the inside of the DGG
15. Put AirBlanc section onto front of Tulip backplug
16. Push Tulip backplug into CT cap
17. Wrap tape onto back of the Tulip backplug until it can fit snugly into the STA barrel
18. Repeat steps 9-17 for the other cap
19. Push assemblies onto STA barrel
20. Complete