NIKoo G3

The NIKoo G3 is a single sided mod made by JEB spinner NIKoo. This mod is a variation of the GJH mod. As Nikpo never released it's tutorial, the mod presented here is a replica.

Construction

Parts needed

List from the UPSB V3:

• 1x G3 (Metalic tip, barrel, grip and cap)
• 1x Jedo (tip)
• 3x HGG (3 tips and 2 grip)
• 1x Dong-A Anyball (grip)
• 1x Grip G-Spec MP (outer and inner grip)
• 1x Pilot AirBlanc (grip)

Additional Items

• Tape
• An insert
• Glue

Text tutorial

Preparation

1. Remove the g3 grip without cutting it.
2. Cut your Airblanc grip to approximately 1.2cm and 1.8cm.
3. Cut a small section and the ring of one HGG grip.
4. Cut your G-spec grip to slightly longer than the previous step
5. Cut 2x 2 blocks of Anyball grip.
6. File the bump of the g3 barrel.
7. Cut the thread part of the g3 front (including its bump).

Assembly

Front side

1. Add 2 blocks of anyball grip and the HGG grip at the front of the G3.
2. Stack the tips in this order inside the HGG grip: G3 tip onto Jedo tip, and Jedo tip onto Hgg tip.
3. Overgrip the HGG grip with: the bigger cut section of Airblanc grip, 2 blocks of Anyball grip and the smaller cut section of Airblanc grip.

Cap side

1. Put the signo tip, g-spec inner grip, HGG ring (in this order) inside the G3 cap.
2. Put the HGG small part onto the G3 cap, overgrip it with the cut outer grip of G-spec
3. Add some tape on the end of the G3 barrel, then connect the G3 cap to it.