Reamtea G3

The Reamtea G3is a personal mod made by JEB spinner Reamtea.

Construction

Parts needed

List from Ponkotu's blog:

• 2x G3 (2 plastic tip and barrel)
• 2x Pentel RSVP Color (2 grips, 1 cap, and 1 barcode sticker)
• 1x Pentel Hybrid Gel Grip (tip)
• 1x Dong-A Anyball (grip)
• 1x Uni-Ball Signo (tip)
• 1x Uni-Ball Lakubo (grip)
  • Original uses a white sub from M&G.

Additional Items

• Tape
• An insert

Text tutorial

Preparation

1. Cut the clip of the RSVP cap.
2. Prepare the G3 barrel by filing the square bump.
3. Cut the G3 grip vertically.
4. Cut 3 blocks of Anyball grip.
5. Cut a RSVP grip after the 1st dimple (Around 5/6mm)
6. Remove the ball inside the RSVP cap.

Assembly

Disassembeled picture of the ReamteaG3

Front side

1. Wrap the RSVP barcode sticker on the front of the G3 barrel.
2. Roll the G3 grip and push it inside the G3 front flat side first, leaving 1 block exposed.
3. Put 3 blocks of Anyball grip on the G3 front.
4. Screw a G3 tip on the front of the G3 barrel and stack another G3 tip then a signo tip onto it. Wrap it in tape to secure it.
5. Cover the remaining exposed part of the G3 front and the tips with the Lakubo grip (Dimple side first)

Cap side

1. Push the HGG tip then a whole RSVP grip into the RSVP cap.
2. Add the small RSVP grip section onto the back of the G3 barrel and push the RSVP cap onto it.
   

   

   
   

References

.