TWPS mod: Difference between revisions
From Fen Spinner Wiki
More actions
Publish wording review of existing tutorial; retain construction without adding a source, per editor direction |
|||
| Line 29: | Line 29: | ||
# Cut both Supergrip grips until you have 3 stripes with flat parts. | # Cut both Supergrip grips until you have 3 stripes with flat parts. | ||
# Hollow both ACT caps. | # Hollow both ACT caps. | ||
# Cut the transparent body so the final mod is | # Cut the transparent body so the final mod is 21 cm. | ||
====Assembly==== | ====Assembly==== | ||
# Stack the Hi-tec tip onto the Signo tip. | # Stack the Hi-tec tip onto the Signo tip. | ||
# | # Place the tipstack into the Supergrip grip (the base of the Signo tip should be at one 3rd of the Supergrip grip stripe side). | ||
# Push one 3rd of the Supergrip grip (stripes side) inside the ACT cap. | # Push one 3rd of the Supergrip grip (stripes side) inside the ACT cap. | ||
# | # Place the silicone tube on the Act cap (with the Supergrip grip under). | ||
# Repeat on the other cap and connect to the transparent body. | # Repeat on the other cap and connect to the transparent body. | ||
==References== | |||
<references /> | |||
[[Category:Pen Mods]] | [[Category:Pen Mods]] | ||
Latest revision as of 17:30, 3 October 2026
 | This article contains leaked information from an anonymous source. The authenticity has been regarded as reasonable by Fenspinner Wiki, but cannot be guaranteed. Fenspinner Wiki has a policy of never disclosing the identity of leakers, and presents the information as-is. |
The TWPS mod is a double-sided KT-type mod made by TWPS.
Construction
Parts needed
- x1 Polycarbonate/Acrylic tube (10mm Outer diameter)
- x2 Ace Art Color Twin (2 big caps)
- x2 Uni-Ball Signo（tips）
- x2 Pilot Hi-Tec-C (tips)
- x2 Pilot SuperGrip (grips)
- x2 2.5cm long silicone tube
- The silicone tube has to fit on the ACT caps
Additional Items
- an insert
Text tutorial
Preparation
- Cut both Supergrip grips until you have 3 stripes with flat parts.
- Hollow both ACT caps.
- Cut the transparent body so the final mod is 21 cm.
Assembly
- Stack the Hi-tec tip onto the Signo tip.
- Place the tipstack into the Supergrip grip (the base of the Signo tip should be at one 3rd of the Supergrip grip stripe side).
- Push one 3rd of the Supergrip grip (stripes side) inside the ACT cap.
- Place the silicone tube on the Act cap (with the Supergrip grip under).
- Repeat on the other cap and connect to the transparent body.