KaD BM2: Difference between revisions
From Fen Spinner Wiki
More actions
No edit summary |
Publish wording review of existing tutorial; retain construction without adding a source, per editor direction |
||
| Line 33: | Line 33: | ||
# Cut two 8.9 cm from the Factis barrel. | # Cut two 8.9 cm from the Factis barrel. | ||
# Cut 1 cm from the Emboss small cap. | # Cut 1 cm from the Emboss small cap. | ||
# Cut one 3 cm and two 4 cm from Comssa barrel ( | # Cut one 3 cm and two 4 cm from Comssa barrel (4 cm pieces should be cut from the front and the 3 cm one from the middle). | ||
# Cut two 4 mm of Tornado grip. | # Cut two 4 mm of Tornado grip. | ||
| Line 39: | Line 39: | ||
# Wrap some tape around the 4 cm Comssa piece then put it inside the Giotto piece (1.5 cm should remain visible). | # Wrap some tape around the 4 cm Comssa piece then put it inside the Giotto piece (1.5 cm should remain visible). | ||
# | # Place the Tornado grip onto the M6 cap nut. | ||
# | # Place the last step onto the Giotto part then slide the V24/39 grip onto it (stretch if necessary). | ||
# | # Place the assembly inside the Factis barrel. | ||
# Repeat. | # Repeat. | ||
# | # Place the 1 cm of Emboss cap on the 3 cm Comssa then connect both Factis barrels onto it. | ||
===Image tutorial=== | ===Image tutorial=== | ||
| Line 49: | Line 50: | ||
==References== | ==References== | ||
<references /> | |||
[[Category:Pen Mods]] | [[Category:Pen Mods]] | ||
Latest revision as of 17:28, 3 October 2026
Construction
Parts needed
Parts list from the picture below:
- x2 Factis BM2 (barrel)
- x2 X-POWER/tome (grips)
- x2 Giotto Turbo Maxi (barrel)
- Only one can be used
- x2 ZhiGao V24/V39 (grip)
- x1 Tsukineko Emboss Dual Pen (small cap)
- x2 Dong-A Com.ssa (barrels)
- x2 M6 cap nut
=Additional items
- Tape
Text tutorial
Preparation
- Cut two 3 cm of Giotto barrel.
- Cut two 8.9 cm from the Factis barrel.
- Cut 1 cm from the Emboss small cap.
- Cut one 3 cm and two 4 cm from Comssa barrel (4 cm pieces should be cut from the front and the 3 cm one from the middle).
- Cut two 4 mm of Tornado grip.
Assembly
- Wrap some tape around the 4 cm Comssa piece then put it inside the Giotto piece (1.5 cm should remain visible).
- Place the Tornado grip onto the M6 cap nut.
- Place the last step onto the Giotto part then slide the V24/39 grip onto it (stretch if necessary).
- Place the assembly inside the Factis barrel.
- Repeat.
- Place the 1 cm of Emboss cap on the 3 cm Comssa then connect both Factis barrels onto it.
Image tutorial
