G3 MX: Difference between revisions
From Fen Spinner Wiki
More actions
Copyedit: restore tutorial from source |
Resolve source review; correct construction and cite tutorial heading |
||
| Line 25: | Line 25: | ||
* An insert | * An insert | ||
===Text tutorial=== | ===Text tutorial<ref>[https://penmodding.pm/archives/431 G3 MX tutorial], Penmodding.pm.</ref>=== | ||
# Cut or file the clip from the G3 cap. | # Cut or file the clip from the G3 cap. | ||
# Remove the G3 tip and ink tube. | # Remove the G3 tip and original ink tube. Keep the tip and replace the ink tube with an RSVP ink tube. | ||
# Poke a hole in the G3 backplug. | # Poke a hole in the G3 backplug. | ||
# | # Seal the open rear end of the RSVP ink tube with tape or cotton to limit leakage. | ||
# | # Insert the RSVP ink tube backwards through the backplug hole, refit the backplug, then place the G3 tip on the front of the G3 body. | ||
# | # Place the HGG grip inside the G3 cap. | ||
# Cut the Anyball grip into four sections. Place one quarter over the G3 grip and one quarter over the G3 cap. | # Cut the Anyball grip into four sections. Place one quarter over the G3 grip and one quarter over the G3 cap. | ||
# Add tape to the back of the G3 body, then attach the G3 cap. | # Add tape to the back of the G3 body, then attach the G3 cap. | ||
Latest revision as of 17:07, 3 October 2026
The G3 MX is a single sided mod made by an unknown spinner.
Construction
Parts needed
List adapted from Penmodding.pm:[1]
- 1x G3 (all parts except the ink tube)
- 1x HGG (grip)
- 1x SGM (grip)
- 1x Pentel RSVP (ink tube)
- 1x Dong-A Anyball (grip)
Additional Items
- Tape or cotton
- An insert
Text tutorial[2]
- Cut or file the clip from the G3 cap.
- Remove the G3 tip and original ink tube. Keep the tip and replace the ink tube with an RSVP ink tube.
- Poke a hole in the G3 backplug.
- Seal the open rear end of the RSVP ink tube with tape or cotton to limit leakage.
- Insert the RSVP ink tube backwards through the backplug hole, refit the backplug, then place the G3 tip on the front of the G3 body.
- Place the HGG grip inside the G3 cap.
- Cut the Anyball grip into four sections. Place one quarter over the G3 grip and one quarter over the G3 cap.
- Add tape to the back of the G3 body, then attach the G3 cap.
References
- ↑ G3 MX tutorial
- ↑ G3 MX tutorial, Penmodding.pm.