G3 MX

The G3 MX is a single sided mod made by an unknown spinner.

Construction

Parts needed

List adapted from Penmodding.pm:

• 1x G3 (all parts except the ink tube)
• 1x HGG (grip)
• 1x SGM (grip)
• 1x Pentel RSVP (ink tube)
• 1x Dong-A Anyball (grip)

Additional Items

• Tape or cotton
• An insert

Text tutorial

1. Cut or file the clip from the G3 cap.
2. Remove the G3 tip and original ink tube. Keep the tip and replace the ink tube with an RSVP ink tube.
3. Poke a hole in the G3 backplug.
4. Seal the open rear end of the RSVP ink tube with tape or cotton to limit leakage.
5. Insert the RSVP ink tube backwards through the backplug hole, refit the backplug, then place the G3 tip on the front of the G3 body.
6. Place the HGG grip inside the G3 cap.
7. Cut the Anyball grip into four sections. Place one quarter over the G3 grip and one quarter over the G3 cap.
8. Add tape to the back of the G3 body, then attach the G3 cap.