View source for Cafca G3 (new ver.)

{{Mod Infobox
|name=Cafca G3 (new ver.)
|image=
|creator=cafca<ref>[https://penmodding.pm/archives/7592 Pen Modding Wiki: Cafca G3 (new ver.)]</ref>
}}

'''Cafca G3 (new ver.)''' is a later version of Cafca G3. It uses a G3 front with a Maica cap assembly and a layered Hyper Jell grip and cap assembly at the rear.<ref>[https://penmodding.pm/archives/7592 Pen Modding Wiki: Cafca G3 (new ver.)]</ref>

==Construction==
===Parts needed===
* 1 Pilot G3 (barrel and grip)
* 1 Pilot Hi-Tec-C Maica (tip and cap)
* 1 Platinum Gel Roller grip
* 1 Pilot Dr. Grip HDG-50R metal ring
* 3 Pentel Hybrid Fine/Hybrid Gel Grip tips
* 1 Hyper Jell, Jimknock or Jimnie grip
* 1 Pilot Hi-Tecpoint V5 or V7 cap
* An insert and tape

[[File:PM-P7592-FfBQTOYagAE93fS.jpg|thumb|Parts diagram by cafca.]]

===Text tutorial===
# Disassemble the G3 and sand down its front.
# File down or cut off the bump on the side of the Maica cap.
# Cut two blocks from the G3 grip and put them on the Dr. Grip metal ring.
# Put the Platinum Gel Roller grip on the front of the Maica cap.
# Put the Hi-Tec-C tip on the gem-shaped part of the Maica cap. Place the Dr. Grip ring, with the two G3 grip blocks fitted to it, over the Maica cap; the Platinum Gel Roller grip holds the ring in place.
# Wrap an insert around the front of the G3 barrel and put the Maica cap onto the G3 front. Add tape if the cap does not hold.
# Remove the metal clip from the Hi-Tecpoint cap.
# Cut the Hyper Jell, Jimknock or Jimnie grip to 2.75 cm, measuring from its rounded front end.
# Stack all three HGG/HGF tips and insert them inverted into the front of the longer Hyper Jell grip section.
# Cut a 4 mm section from Hyper Jell grip and insert it through the cut end into the longer grip section.
# Put the long grip section into the Hi-Tecpoint cap with its tip end going in first.
# Tape the rear of the G3 and attach the prepared cap.



==References==
<references />

[[Category:Pen Mods]]