Shisones Comssa

Shisones Comssa is a double-capped Comssa mod by Shisones. It uses layered G2, Sailor Gel, G3, and Coral Everline grips with stacked Hybrid Technica and Hi-Tec C tips.

Construction

Parts needed

• 1 Dong-A Comssa body and two caps
• 2 Pilot G2 grips
• Sailor Gel grip
• Pilot G3 grip
• 2 Coral Everline grips
• 2 Pentel Hybrid Technica tips
• 2 Pilot Hi-Tec C tips

Tutorial

1. Disassemble the G2 pens. Cut three ridges from the front of each G2 grip and keep the smooth grip sections. Cut three-ridge sections from both ends of the Sailor grip and two three-ridge sections from a G3 grip.
2. Cut 2cm from the rear of each Coral Everline grip. Take one Hybrid Technica tip and one Hi-Tec C tip for each end.
3. Screw a Hybrid Technica tip into the centre of a Comssa cap. Stack a Hi-Tec C tip above it and cover the stack with a three-ridge G3 grip section.
4. Build the grip stack from three G2 ridges, three Sailor ridges, and the smooth G2 section, with its ring beside the Sailor grip. Cover the smooth G2 section with a 2cm Coral Everline grip.
5. Repeat for the other end. Use old Sarasa grip instead of Coral Everline for a lighter mod, or six Anyball grip blocks for a heavier one. HGG tips may replace the Hybrid Technica tips. If long Comssa back plugs make the mod unbalanced, add an RSVP metal ink nib and Teflon tape at the front.