Revolution MX

The Revolution MX is a single-sided mod by KIRGO, using a Hybrid Gel Grip body joined to a Mini RSVP rear section. It measures 18.2 cm and weighs 12 g.

Construction

Parts needed

• 1x HGG (body, grip, tip, and ink tube)
• 1x Pentel RSVP Mini (barrel, grip, and cap)
• Optional decorative insert (type and placement unspecified)
• Tape

Text Tutorial

1. Cut the Mini RSVP barrel at the former grip end and fit the HGG tip over the RSVP tip.
2. Cut a 1.4 cm section from the HGG barrel near its grip end.
3. Tape the HGG ink tube and insert it into the HGG barrel section. Fit the cut RSVP barrel over the front and cover the joint with the HGG grip.
4. Let the HGG ink tube extend at the rear. Secure the RSVP backcap to the tube with tape and fit the RSVP grip over it, leaving the HGG backcap exposed as illustrated.
5. Cut the HGG cap’s rubber ink stopper in half and fit the smaller halves into the Mini RSVP cap opening. Place that cap at the rear.