Fukrou's G3
From Fen Spinner Wiki
More actions
Fukrou's G3 is a series of personal mods made by JEB spinner Fukrou.
Construction for Fukrou G3 V1
List of V1 and V2 from Fukrou's blog:[1]
Parts needed
- 1x Plastic G3 (barrel and tip)
- 2x Pilot Hi-Tec-C (tip)
- 1x HGG or HF (grip)
- 1x Hyperjell (cap)
- 1x Signo DX (tip and grip)
- 1x Signo Broad (grip)
- 1x Supergrip MP (grip)
Text tutorial
- Prepare the G3 front, keeping its plastic tip and rear backplug.
- Stack the plastic G3, Signo and Hi-Tec-C tips on the front, in that order. Secure the stack with clear tape. Fit an approximately 8 mm Signo grip section over the front, followed by a full HF or HGG grip.
V1 front assembly. - Remove and smooth the Hyper Jell cap clip. Insert the second Hi-Tec-C tip, one rear SuperGrip ring including its protruding rim, and a 2.5 cm Signo Broad grip section into the cap, in that order.
V1 rear assembly. - Wrap vinyl tape around the rear of the G3 barrel, keeping its backplug fitted. Attach the prepared Hyper Jell cap.
- Add an optional insert.
Construction for Fukrou G3 V2
Parts needed
- 2x Plastic G3 (barrel, grip and 2 tips)
- 1x Zebra Hyper Jell or Zebra Jimnie Knock (grip)
- 1x Uni-Ball Air (cap)
- 2x Signo (2 tips)
- 1x Pilot SuperGrip (grip)
Text tutorial
- Prepare the G3 front, keeping its backplug. Hollow one of the two plastic G3 tips by removing its internal protrusion.
- Stack the intact plastic G3, hollowed plastic G3 and Signo tips on the front, in that order. Fit a five-ring SuperGrip section over the front, followed by a full Hyper Jell grip. A Jimnie Knock grip can substitute for the Hyper Jell grip.
- Remove and smooth the Uni-Ball Air cap clip. Insert the second Signo tip, G3 grip and a three-ring section from the rear of the SuperGrip grip into the cap, in that order.
- Wrap one turn of clear tape around the rear of the G3 barrel if needed, then attach the prepared Air cap with the G3 backplug fitted.
- Add an optional insert.
