Frat MX3

The Frat MX3 is a double-sided mod made by Fratleym.

Construction

Parts needed

List from Penspinning.fr

• x1 Rox Mx (with training caps)
• x2 Pilot G1 (tips)
  • For the Metallic version
• Lots of grips

Additional Items

• Patafix

Text tutorial

1. Remove the black end pieces from the Rox MX training caps, leaving their outer ends open.
2. Cut a 4 cm length of thin grip into two 2 cm sections.
3. Remove the original barrel caps. Fit a 2 cm grip section over each exposed metal barrel end, then push a training cap approximately 1 cm into that grip.
4. Add weight inside the caps as desired. Fratleym used a small amount of Patafix adhesive putty.
5. Add decorative G2 grips to the caps. Fit a clear outer grip over part of the decorative grip and extend it to the end of the cap. The grip lengths can be adjusted.
6. For the metallic version, insert a G1 tip into the open end of each cap.
   

   

   
   
7. Adjust the length to your preference.
   

   

   The three Frat MX versions; MX3 is the bottom mod.