BT MX

BT MX is Mina’s extended Stalogy-based MX mod. Mina describes its spinning feel as similar to an MX.

Construction

Parts needed

• Nitoms Stalogy barrel (BP or MP)
• Bic Round Stic barrel
• Pentel HGG or HGR tip and grip
• Pentel RSVP cap and grip; tape if needed

Text tutorial

1. Disassemble the Stalogy and cut about 2 cm from its rear, adjusting to the length wanted.

   

   Step 1.

   
   

2. Cut the Bic Round Stic from the front to 3.5 cm, excluding the tip.

   

   Step 2.

   
   

3. Fit the HGG tip onto the Bic front. An HGR tip may need tape or a G3 rubber to hold it in place.

   

   Step 3.

   
   

4. Slide the HGG or HGR grip onto the Bic barrel.
5. Remove the RSVP cap clip and fit the RSVP grip inside.

   

   Step 5.

   
   

6. Insert the Bic assembly into the front of the Stalogy barrel, then fit the RSVP cap over the cut rear; use a little tape if needed.

   

   Step 6.