Wanna VP

Wanna VP is a single-sided RSVP-based mod created by wanna. Its length varies with cap depth, with measurements of 18–19 cm reported. The listed build is 19 cm, while wanna later gave a length of 18 cm.

Parts needed

• 1 Pentel RSVP body
• 1 Pilot G3 cap
• 2 Uni-ball Signo Broad tips and 1 Signo Broad grip
• 1 Pentel Hybrid Gel Grip tip
• 1 Uni Lakubo grip
• 1 Uni Jetstream SXN-155 tip
• 1 Dong-A Anyball grip
• Spare grip pieces

Text tutorial

1. Disassemble the RSVP. Remove its backplug and screw the Jetstream tip onto the rear threads; file the threads slightly if needed so the tip seats fully. Add an insert to the body.
2. Remove the G3 cap clip and its rubber stopper.
3. Put two Anyball grip blocks into a Signo tip, then place the Signo tip inside the G3 cap.
4. Put the Signo Broad grip in the G3 cap and attach the cap to the RSVP body.
5. Screw the HGG tip onto the front of the RSVP. Put a Signo tip over the HGG tip and secure it with tape.
6. Put the Lakubo grip on the front of the RSVP. Fill any remaining gap with spare grip; the creator used cut Lakubo grip.