Sonoda Emboss

Sonoda Emboss is a double-ended Emboss mod by Sonoda, measuring 23 cm. Vôre-Tèx’s build weighs 21 g.

Construction

Parts needed

• 2 Emboss Dual Pens (barrels)
• 2 Zebra Airfit BA-9 (tips and grips)
• 1 Pentel RSVP (barrel and cap)
• 1 Pilot G3 grip
• 1–2 Dong-A Anyball grips
• A paper insert

Text tutorial

1. Empty the Emboss barrels and cut each to 9 cm.
2. Cut the RSVP barrel to 4 cm and the cap to 1.5 cm. A Color Twin barrel can replace the RSVP barrel if this cut is difficult.

   

   

3. Wrap an insert around the middle of the cut RSVP barrel and fit the short RSVP cap over it. Place a G3 grip section on either side.

   

4. Join the two Emboss barrel sections with this center piece.
5. Add five Anyball grip rings total across the two ends as shown in the photographs, then place one half of an Airfit grip on each end.
6. Fit an Airfit tip into each end grip.