Sherry G3
From Fen Spinner Wiki
More actions
Sherry G3 is Sherry’s G3 mod, measuring about 19.5 cm and weighing 15 g.[1][2]
Construction
Parts needed
- 1 plastic Pilot G3 body and tip
- 1 Pilot Multi Ball cap
- 2 Uni-ball Signo DX tips and grip
- Zebra Hyper Jell grip
- Pilot Hi-Tec C tip
- Decorative grip sections
Tutorial
- Remove the clip and rubber stopper from the Multi Ball cap. Fit a Signo tip inside the cap, then add a 2.7cm section of Hyper Jell grip.
- Clear and sand the front of the G3 barrel. Fit about 2cm of decorative grip over the front.
- Stack the G3 tip, Hi-Tec C tip and Signo tip in that order. Cover the stack with a full Signo grip and fit it into the front of the G3.
- Tape the rear of the G3 barrel and connect the cap assembly.[1][2]