RSVP NX MMT DX

RSVP NX MMT DX is an RSVP-based mod by Kr4zy. It measures 21 cm, weighs 16 g, and is difficult to build.

Construction

Parts needed

• 1 RSVP pen (body, cap and clicker)
• 1 Pilot G2 body and clicker
• 2 Pentel Hybrid Gel Grip pens (two tips and one grip)
• 1 Hybrid Gel Grip DX tip
• 1 RSVP grip
• 1 SGM, Anyball, or Profile grip band

Tutorial

1. File the front of the RSVP body and fit the small part of the G2 clicker over the RSVP tip.
2. Cut 5.6cm from the G2 barrel. Place an insert inside it and fit the barrel over the front of the RSVP body.
3. Cut 0.7cm from the larger part of the G2 clicker. Attach the HGG DX tip to this piece and fit it over the smaller G2 clicker piece at the front.
4. Remove the clip from the RSVP cap and fit an HGG tip inside. Place the SGM grip band inside the RSVP grip, then fit the RSVP grip over the cap.
5. Fit the second HGG tip into the RSVP grip inside the cap, with about 0.6cm of HGG grip around it. A short HGG or RSVP grip piece can keep the tip from moving.
6. Add the insert, replace the RSVP back cap and fit the cap assembly onto the body.