PPM Emboss Mod
From Fen Spinner Wiki
More actions
The PPM Emboss Mod is PPM (PooPooMan)’s double-sided Emboss mod, designed for a heavier power-style build. It measures 22.5 cm and weighs 28 g.[1][2]
Construction
Parts needed
- 2x Tsukineko Emboss Dual Pens (barrels)
- 2–3x Sailor Gel or IC Liquid pens (grips and two caps)
- 2x Tornado or Daiso HealthyGrip pens (grips)
- 2x Zebra Airfit mechanical pencils (tips)
- 1x Crayola Supertips (cap)
- 1x Anyball grip
- Electrical tape and clear tape [1]
Text Tutorial
- Empty both Emboss barrels and remove their front tips. Cut two Sailor caps to 2.5 cm and the Supertips cap to 3 cm.
- Wrap clear tape around the front of each Emboss barrel until the Sailor caps fit snugly. Fit the Sailor caps with their cut ends facing outward.
- Wrap a 0.5 cm-wide electrical-tape strip around the middle of the Supertips cap, then use that cap to join the two Emboss barrels. Keep this tape on the Supertips cap rather than the Emboss barrels.
- Cut six Sailor grip sections: two four-block pieces and four three-block pieces. Cut two five-block Tornado grip sections. Arrange the Sailor sections on the Sailor caps in this order: three blocks, three blocks, four blocks, then Tornado grip.
- Cut four three-block Anyball sections. Nest two sections together on each Airfit tip, then push each tip into a Tornado grip section. If a tip is difficult to insert, fold the grip down temporarily and restore it after insertion. [1]
Video tutorial
PPM Emboss Mod construction tutorial by PooPooMan.[2]