IMaker

iMaker is a mod by iMatt, measuring 19.1 cm with a medium to heavy weight. It uses inserts and is moderately difficult to build.

Construction

Parts needed

• 1 RSVP (all parts)
• 1 G3 cap
• 2 HGG pens (1 grip and 2 tips)
• 2 HGR tips, or 1 Signo tip
• 1 Uni-ball Jetstream tip
• A toothpick and inserts

Text tutorial

1. Remove the RSVP back cap and file its rear until the Jetstream tip can screw on.
2. File the back of the Jetstream tip.
3. Screw two HGG tips onto the Jetstream tip and attach it to the RSVP back. Cut 1.6 cm from the RSVP grip and fit it over the HGG tips.
4. Put a toothpick in the RSVP ink tube to extend it by 0.5 cm, then replace the tube in the body.
5. Cut the RSVP clip and put a 2.5 × 2.5 cm insert in the cap.
6. Put a 4.25 × 2.5 cm insert over the Jetstream/HGG/RSVP grip assembly.
7. Carefully fit the RSVP cap over this insert.
8. Put an HGG grip over the RSVP undergrip, then add an RSVP ring at its end.
9. Cut the G3 cap to 3.9 cm.
10. Cut 0.9 cm from the RSVP grip and fit it over the Signo tip and two HGR grips.
11. Put this assembly inside the G3 cap.
12. Wrap an insert around the HGG grip and fit the G3 cap over it.