A13x Bullet Mod (Vore-tex ver.)

The A13x Bullet Mod (Vore-tex ver.) is a revision of the popular A13x Bullet Mod using archery bullet tips and recent versions of the old parts.

Construction

Parts needed

List from the video bellow:

• 1x Pilot Dr. Grip（Grip）
• 1x Giotto Turbo Maxi (Body)
• 1x big Veleda White Board Marker (cap)
• 1x Pentel Color Twin (Small cap)
• 1x Edding 661 (cap)
• 1x Pilot SuperGrip (Grip)
• 1x Pentel RSVP (Grip)
• 2x Archery bullet tips

Additional Items

• Cello tape and Electrical tape

Text tutorial

Preparation

1. Cut ~3.3 cm of the Velleda cap.
2. Disassemble the Giotto and cut the front until it's ~1cm
3. Cut your Dr. Grip grip into 2x 2cm sections.
4. Cut your RSVP grip 2 times: 1 to separate the o-ring and another one at 2/3 of the grip (one part is slightly longer than the other).
5. Cut 2 sections of SuperGrip grip, 1x 4 stripes and 1x 2 stripes.

Front side

1. Put the bullet tips inside the Edding cap (some tape might be necessary).
2. Add these grips on the Edding cap following this order: 4 stripes of G2 grip, the smaller section of RSVP grip, and one side of Dr. Grip grip.
3. Connect the Edding cap on the Color Twin small cap.

Back side

1. Add these grips on the Velleda cap following this order: the longer section of RSVP grip turned inside out, 2 sections of SuperGrip grip, and the last side of Dr. Grip grip.
2. Put the bullet tips inside the Velleda cap (tape might be necessary to avoid rattling).
3. Add your RSVP o-ring on the front of the Giotto, and add cello tape on the rest of the front.
4. Put the Color Twin small cap inside the back of the Giotto barrel.
5. Connect the old Velleda cap on the front of the old Giotto barrel.

Video tutorial

Video tutorial by VORE-TEX.