Laluteskal Ballsign

The Laluteskal Ballsign is a double-sided mod made by JEB spinner Laluteskal.

Construction

Parts needed

Parts list from Ponkotu's blog

• 1x Sakura Ballsign (1 body)
• 4x Pilot SuperGrip (4 grips)
• 2x Pilot Dr. Grip (grip)
• 2x Tombow Playcolor2 (clipless caps)
• 2x Pilot AirBlanc (grip)
• 2x Ohto Needle Point (tips)
• 1x Penzgear (two rings)

Additional items

• An insert

Text tutorial

Preparation

1. Empty the Ballsign barrel and add an insert if desired.
2. Separate the smooth and ribbed sections of all four SuperGrip grips. Keep the ribbed sections.
3. Cut two small Dr. Grip sections for the outer overgrips.
4. Cut two Airblanc sections, each approximately the length of four SuperGrip rings.

Assembly

1. Fit one ribbed SuperGrip section onto the inner half of a Playcolor2 cap, leaving room for the outer grip assembly. Cover it with an Airblanc section.
   

   

   
   
2. Insert a Needle Point tip and one Pen’z Gear ring into another ribbed SuperGrip section.
   

   

   
   
3. Cover this outer section with a small Dr. Grip section, then fit it onto the outer end of the cap.
   

   

   
   
4. Repeat the assembly on the second Playcolor2 cap.
5. Fit both prepared caps onto the Ballsign barrel.