Eban G3

The Eban G3 is a personal mod made by JEB spinner Eban.

Construction

Parts needed

List from Ponkotu's blog:

• 1x Plastic G3 (barrel, plastic tip)
• 2x Pilot Hi-Tec-C (tip)
• 1x HGG (grip)
• 1x Hyperjell (cap, grip)
• 1x Signo (tip)

Text tutorial

1. Remove the Hyper Jell cap clip.
2. Remove the G3 grip, ink tube, tip and backplug. Sand down the nubs and front of the barrel to prepare it.
3. Fit the plastic G3 tip onto the front, then stack the Signo tip over it and the Hi-Tec-C tip over the Signo tip.
   

   

   
   
4. Cut a 1 cm section of Hyper Jell grip and fit it over the front. Fit the full HGG grip over it to cover the front and tip stack.
5. Place the second Hi-Tec-C tip and the remaining Hyper Jell grip inside the Hyper Jell cap.
   

   

   
   
6. Add an insert to the G3 barrel. Wrap tape around the rear of the barrel and attach the Hyper Jell cap.