Ivan Giotto

The Ivan Giotto is a double sided mod made by FPSB modder, VoreTex. It was made for VicGotGame for his project: "X incipiens stabilus".

Construction

Parts needed

List from the video below

• x2 Giotto Turbo Maxi (2 body, 2 backplugs)
• x2 Pilot Dr.Grip (Grips) (facultative: fronts)
• x2 O-ring
• x2 Decorative grips (original use base of Z-grip and 4 o-ring for 1 side)
• x2 Archery bullet tips

Additional Items

• Tape

Text tutorial

Preparation

1. Cut the front and dissasemble both Giotto barrel.
2. Cut the Giotto backplug from the ring
3. Cut 1 of the 2 Giotto body in half.
4. Cut the 2 Dr.Grip grips in half and (facultative) cut the front to roughly the same size as the 2 Archery bullet tips

Assembly

1. Put one giotto backplug in each hole of the uncuted Giotto body
2. Add one O-ring on each backplug, connect the 2 half of the cutted Giotto barrel. (tape might be necessary to hold the parts well)
3. Add some tape around the Archery bullet tip (connect with the Dr.Grip front, this should prevent the tips from falling)
4. Put the Archery bullet tip in the Ivan giotto base, it should fit snug.
5. Add the Decorative grip then add one half of Dr.Grip
6. Repeat on the other side

Video tutorial

Video tutorial by VoreTex.